Loading ...
Loading ...
Loading ...
CARE AND CLEANING
Control Panel - clean with a soft, damp cloth. Do not use
abrasivesubstances. Do not spray cleaners directly on the
panel.
Tumbler - remove any stains such as crayon, ink pen or fabric
dye (from new items such as towels or jeans) with an all-
purpose cleaner. Then tumble old towels or rags to remove any
excess stain or cleaning substance. Once these steps are done,
stains may still be visible, but should not transfer to subsequent
loads.
Cabinet - wipe off any marks with soap and water.
Drying Cabinet Interior - clean with soft, damp cloth. Do
not use abrasive substances. Clean the right side of the drying
cabinet interior with a dusting wand or vacuum with upholstery
attachment. \
Dryer Exhaust System - should be inspected and cleaned
once a year to maintain optimum performance.The outside
exhaust hood should be cleaned more frequently to ensure
proper operation. (Refer to the Installation Instructions for
more information.)
Water Reservoir - clean with soap and water and a soft
cloth. Rinse and dry thoroughly.
Water Reservoir Filter - Liftfilter out of slot. Clean with
soap and water and a soft brush. Rinse and dry thoroughly.
Water Bottle, Lid and Lid Insert - clean with soapand
waten Rinsethoroughly.
REPLACE DRUM LIGHT
Instructions for replacing the bulb: 4)
I) Unplug or disconnect the dryer from the power supply.
2) Remove lens cover from inside of drum by removing the
two screws. S)
3) Push bulb in and rotate counterclockwise to remove. 6)
Replace with a 25 watt, II 5/125 volt twist lock utility light
Part No. 53-0570 or equivalent. Place bulb in socket, push
in and rotate clockwise.
Reinstall lens cover and two screws.
Reconnect dryer to power supply.
REPLACE DRYING CABINET LIGHT
Instructions for replacing the bulb:
I) Unplug or disconnect the dryer from the power supply.
2) Remove phillips screw from lens cover.
3) Squeeze sides of lens cover to remove.
4) Rotate bulb counterclockwise to remove.
5) Replace with a 120 volt, 10 watt maximum candelabra-base
light bulb.
6) Snaplens cover back into place.
7) Replace phillips screw in lens cover.
8) Reconnect dryer to power supply.
REVERSE THE DOOR
Instructions for reversing the dryer door:
I) Remove two screws from each hinge hole cover and
remove hingehole covers.
2) While supporting the door, remove screws that secure the
hinges to the cabinet (two each).
3) Move the following parts to the opposite side of the door:
two hinges,four hinge screws, four door screws, door
strike and screw, inner door cover plate and screw.
4) Attach the door to the opposite side of the cabinet using
the four counter sunk hinge screws. (See below).
5) Replace the hinge hole covers to the opposite side.
,-- Doc_ Ce!ch •
f
: ; ,_" ". , , Hing e
Hele
12
Cc_ter Sunk _rew _ i
_- IPDoor
Sl_ike
Loading ...
Loading ...
Loading ...