Loading ...
Loading ...
Loading ...
9 — English
OPERATION
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
Grinding metals
Sanding wood or metal surfaces
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
INSTALLING/REMOVING BATTERY PACK
See Figure 3, page 13.
To install:
Insert the battery pack.
Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove:
Depress the latches on each side of the battery pack.
For complete charging instructions, see the operator’s manu-
als for your battery pack and charger.
STARTING/STOPPING THE ANGLE GRINDER
See Figure 4, page 13.
The lock-off button, located on the handle above the switch
trigger, reduces the possibility of accidental starting.
To turn the tool ON:
Install the battery pack.
Hold the tool in front and away from you, keeping the
wheel clear of the workpiece.
To start the tool, grasp the handle and side handle firmly.
Slide the lock-off button to the unlocked position and
squeeze the switch trigger.
To turn the tool OFF:
To stop the tool, release the switch trigger. Make sure the
tool comes to a complete stop before laying down the
tool.
When task is completed, engage the lock-off button. The
switch trigger should not be able to depress.
CAUTION:
The lock-off button should be in the locked position when
the tool is not in use or is being transported.
POSITIONING THE GUARD
See Figures 5 - 6, pages 13 and 14.
The guard on the grinder should be correctly positioned
depending on which side the handle is mounted. Never use
the grinder without the guard correctly in place.
WARNING:
Never place the guard so that it is in front of the grinder.
This could result in serious injury because sparks and
loose particles thrown from the grinding wheel would be
directed toward the operator. Always place the guard in
the correct location as shown.
To reposition the guard:
Remove the battery pack.
Unlock the guard by holding the latch and pulling away
from the grinder.
Rotatetheguardtoitscorrectpositionasshown.
Locktheguardbypushinginuntillatchclicksintoplace.
NOTE: Be sure the raised ridge on the guard is seated
in the groove on the bearing cap. Never use the grinder
without the guard in place and properly adjusted.
OPERATING THE GRINDER
See Figure 7, page 14.
Always carefully select and use grinding wheels that are
recommended for the material to be ground. Make sure
that the minimum operating speed of any accessory wheel
selected is 9,000/min. or more. The grinding wheel provided
with the grinder is suitable for grinding welds, preparing
surfaces to be welded, grinding structural steel, and grinding
stainless steel.
To operate the grinder:
Secure all work in a vise or clamp to a workbench.
DANGER:
Never use the grinder with the guard removed. It has been
designed for use only with the guard installed. Attempt-
ing to use grinder with guard removed will result in loose
particles being thrown against the operator resulting in
serious personal injury.
Hold the grinder in front and away from you with both
hands, keeping the grinding wheel clear of the workpiece.
Loading ...
Loading ...
Loading ...