Loading ...
Loading ...
Loading ...
Problem solving guide
106
Problem Possible cause and remedy
The optical in-operation
indicator light is
flashing quickly.
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
Fault F601
There is a fault with the AutoDos.
Switch the dishwasher off and back on again.
Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see
“Detergents – Automatic dispensing/AutoDos”).
Activate the AutoDosfunction and start the
programme again.
If the fault message appears again, there is a
technical fault. You can continue to use your
dishwasher by deactivating automatic dispensing
with the AutoDossensor and manually dispensing
the detergent via the detergent compartment.
If you wish to use automatic dispensing again,
contact Miele.
The optical in-operation
indicator light is
flashing quickly.
At the end of the
programme, the alarm
tone sounds and the
display shows the
following message:
AutoDos maintenance
required
The dishwasher does
not switch off at the end
of the programme.
The dishes may not be
clean because an
insufficient amount of
detergent was
dispensed.
The AutoDos
function is
automatically
deactivated during the
programme sequence.
An empty PowerDisk has been inserted or the
AutoDos is blocked by residual detergent. The
detergent dosage is insufficient.
The AutoDos function was automatically
deactivated.
Switch the dishwasher off and back on again.
Multiple messages appear in the display.
Clean the detergent chute of the AutoDos (see
“Cleaning and care - Cleaning the AutoDos”).
Clean the lower spray arm (see “Cleaning and care
- Cleaning the spray arms”).
Confirm each message with OK.
Activate the AutoDos function by confirming the
message AutoDos available with OK.
Restart the programme.
The programme duration will be extended by up to
2.5hours to flush out the AutoDos detergent outlet.
Loading ...
Loading ...
Loading ...