Loading ...
Loading ...
Loading ...
Not for
Reproduction
13
Troubleshooting
Problem Cause Correction
Pump has following
problems: failure to
produce pressure, loss
of pressure, low water
volume.
1. Low pressure spray tip installed.
2. Pressure control knob is turned to low
spray pressure setting.
3. Inadequate water supply.
4. Clogged inlet hose screen.
5. Spray tip is obstructed.
6. Connections leak.
7. High pressure hose or spray gun leaks.
1. Replace with high pressure spray tip.
2. Turn pressure control knob clockwise to
increase spray pressure.
3. Provide adequate water ow.
4. Check and clean inlet hose screen.
5. Clean spray tip. See Spray Tip
Maintenance.
6. Tighten connections or replace o-rings.
7. Replace.
Detergent fails to mix
with spray.
1. High pressure spray tip installed.
2. Check ball stuck in detergent
siphoning system.
3. Detergent siphoning tube is clogged or
cracked.
1. Replace with low pressure black spray tip.
2. Free check ball. See Detergent Siphoning
Check Ball.
3. Clean or replace detergent siphoning
tube.
Engine will not start;
starts and runs rough
or shuts down during
operation.
1. Out of fuel.
2. Flooded with fuel.
3. Dirty air lter.
4. Spark plug wire not connected to spark
plug.
1. Fill fuel tank.
2. Wait 5 minutes before starting.
3. Clean or replace air lter.
4. Connect wire to spark plug.
For all other issues, see an authorized dealer.
*This pressure washer is rated in accordance to the Pressure Washer Manufacturers’ Association (PWMA) standard PW101-2010
(Testing and Rating Performance of Pressure Washers).
Specications
Pressure and Flow ............................4200 PSI (290 bar) @ 4.0 GPM (15.1 L/min)*
Water Supply Temperature .....................................41°F (5°C) - 100°F (38°C)
min Water Supply Flow Rate ...................................... 5.0 GPM (18.9 L/min)
min Water Supply Pressure ...........................................20 PSI (1.38 bar)
Pump Oil Capacity ................................................... 10 oz (0.3 Liters)
Loading ...
Loading ...
Loading ...