Loading ...
Loading ...
Loading ...
9
below -9℃,changes in lubricant properties may present possibility of damage or
injury, and in that conditions the work duty is reduced than normal operating
conditions.
4.Hoist operation is controlled by depressing the control station push buttons.
Depressing the “up” push button will move the load hook toward the hoist;
depressing the “down” push button will move the load hook away from the hoist.
5.The “up” and “down” buttons are momentary type and the hoist will operate in
the selected direction as the long as the button is held in the depressed position.
Release the push button and the hoist will stop.
6.When preparing to lift a load, be sure that the attachments to the hook are firmly
seated in hook saddle. Avoid off center loading of any kind, especially loading on
the point of the hook.
7.When lifting, raise the load only enough to clear the floor or support and check to
be sure that attachment to the hook and load are firmly seated. Continue lift only
after you are assured the load is free of all obstructions.
8.Do not use this hoist out of its work duty.
9.Stand clearing of all loads and avoid moving a load over heads of other heads of
other personnel. Warn personnel of your intention to move a load in their area.
10.Do not leave the load suspended in the air unattended.
11.Permit only qualified personnel to operate unit.
12.Do not wrap the load chain around the load and hook on itself as a choker
chain.
13.Do not allow a load to bear against the hook latch. The latch is to help maintain
the hook in position while the chain is slack before taking up the slack chain.
14.Take up a slack load chain carefully and start load easily to avoid shock and
jerking of hoist chain. If there is any evidence of overloading, immediately lower
the load and remove the excess load.
15.When the push button is pressed, the machine will stop.
Periodic Inspection
To maintain continuous and satisfactory operation ,a regular inspection procedure
must be initiated so that worn or damaged parts can be replaced before they
become unsafe, the intervals of inspection must be determined by the individual
application and are based upon the type of service to which the hoist will be
Loading ...
Loading ...
Loading ...