Loading ...
Loading ...
Loading ...
11 ENGLISH
Work posture
Maintaining proper operating position is one of the most
importantandeectiveproceduresforcontrollingkickback.
Keep proper positioning by practicing the following points.
•
Position the tool so that the bar of the reaction
receiver always contacts on the left side of your waist.
• Grasp the handle and the side handle with both
hands.Wrapyourngersaroundthegripping
areas, keeping the gripping areas cradled
betweenyourthumbsandforengers.
• Keep your back as vertical as possible by bending
the legs as required during the digging process.
• Stay alert to the torque reaction force of the tool.
Always keep the operating position that you can
withstand the torque reaction force.
1
2
3
3
1
2
►1. Handle 2. Side handle 3. Bar of the reaction
receiver
WARNING: Avoid improper positioning. Do
not stand too far from the tool. Proper reaction and
control may not be achieved in the event of kickback.
Digging operation
CAUTION: Hold the tool rmly when operat-
ing the tool.
CAUTION: When leaving the tool, such as
during a break, do not leave the tool stabbed in
the ground or lean it against a wall. Store the tool
in a stable condition.
NOTICE: When the rotation speed comes down
extremely, reduce the load or stop the tool to
avoid the tool damage.
NOTICE: Pressing excessively on the tool will
not speed up the digging. In fact, this excessive
pressure will only serve to damage the tip of the
auger bit, decrease the tool performance and shorten
the service life of the tool.
NOTICE: Avoid digging in material that you
suspect contains hidden nails or other things that
may cause the auger bit to bind or break.
NOTICE: If the tool is operated continuously
until the battery cartridge has depleted, allow the
tool to rest for 15 minutes before proceeding with
a fresh battery.
•
When digging a deep hole or digging in clay soil, do not
try to dig at once. Dig the hole by lifting up and down
the tool so that the soil in the hole can be discharged.
• If the rotation speed of the tool slows down due to
high load operation, lift the tool up little, and move
the tool up and down to dig in small steps.
When rotating the auger bit in reverse
A stuck auger bit can be removed simply by setting the
reversing switch to reverse rotation in order to back out.
When reversing, brace the tool by your body to prevent
a clockwise reaction.
CAUTION: Hold the tool rmly. The tool may
backoutabruptlyandcauseaninjury.
MAINTENANCE
CAUTION: Always be sure that the tool is
switched o and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs,anyothermaintenanceoradjustmentshould
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Loading ...
Loading ...
Loading ...