Loading ...
Loading ...
Loading ...
13
Other UPS Features (Rear Panel)
AC Bypass Alarm Switch (Select Models): If the UPS system
experiences a processor fault or if the internal battery is completely
depleted, the AC bypass will pass through AC power to connected
equipment and the audible AC bypass alarm will sound continuously. If
you need to silence the AC bypass alarm, move the “AC Bypass Alarm”
switch to the “Disable” position. Contact Tripp Lite for assistance at
773.869.1234.
AC Outlets: All models include NEMA 5-15R and/or
NEMA 5-20R outlets. Select models also include NEMA
L5-30R outlets. These outlets provide your connected
equipment with AC line power during normal operation
and battery power during blackouts and brownouts. The
UPS protects equipment connected to these outlets
against damaging surges and line noise. If you have a
serial or USB connection to your UPS, you can remotely
reboot connected equipment by turning the outlets OFF
and ON using Tripp Lite’s PowerAlert Software. The outlets
are divided into one or more load banks (labelled “LOAD
1,” etc.) which may be remotely switched OFF and ON
without interrupting power to equipment connected to the
other outlets. Outlets labelled “UNSWITCHED” may not be
remotely switched off.
Communications Ports (USB or RS-232): These ports connect your
UPS to any workstation or server. Use with Tripp Lite’s PowerAlert Software
and included cables to enable your computer to automatically save open
files and shut down equipment during a blackout. Also use PowerAlert
Software to monitor a wide variety of AC line power and UPS operating
conditions. Consult your PowerAlert Software manual or contact Tripp Lite
Customer Support for more information. See USB and RS-232 Serial
Communications in the Optional Installation section for installation
instructions.
EPO (Emergency Power Off) Port: Your UPS features an EPO port that
may be used to connect the UPS to a contact closure switch to enable
emergency inverter shutdown. See Optional Installation.
Basic Operation
“BATTERY WARNING” LED: This LED illuminates red and an alarm sounds
intermittently after you initiate a self test (See “MUTE/TEST” Button
description) to indicate the UPS batteries need to be recharged or
replaced. Allow the UPS to recharge continuously for 12 hours, and repeat
the self-test. If the LED continues to illuminate, contact Tripp Lite for
service. If your UPS requires battery replacement, visit www.tripplite.com to
locate the specific Tripp Lite replacement battery for your UPS.
15A 120V
NEMA 5-15R
20A 120V
NEMA 5-20R
30A 120V
NEMA L5-30R
19-01-060-932757.indb 13 1/21/2019 9:56:42 AM
Loading ...
Loading ...
Loading ...