Loading ...
Loading ...
Loading ...
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
Using a Timer
Your watch provides you with two different
types of timers. Select the timer you want to
suit your needs.
●
Repeat Timer
With the Repeat Timer, countdown stops
and the start time setting appears when the
end of the countdown is reached.
The Repeat Timer comes in handy when
you need to perform the same countdown
operation a number of times.
●
Auto Repeat Timer
With Auto Repeat Timer, the countdown
operation is automatically restarted from the
start time when the end of the countdown is
reached. This continues until you stop the
countdown operation.
●
Time Up Beeper
The watch beeps at various points in the
countdown starting from five minutes before
the end of a countdown.
●
You can disable the beep, if you want.
The watch beeps at the points shown in the
table below while the beep is enabled.
Remaining time Beep
5 minutes 10 seconds to
5 minutes
Every second
4 minutes to 1 minute Every minute
30 seconds 1 second
10 seconds to 0 seconds
(Time Up)
Every second
●
If the start time is under five minutes, the
beep operations will be performed part way
through the above sequence.
An alarm will sound for one second to let you
know when the end of a countdown is
reached.
Setting the Time
The countdown start time can be set in 1-
minute units up to 24 hours.
●
If a timer countdown operation is in
progress, reset the timer to its current start
time before performing this operation.
l
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
2. Hold down (A) for at least one second.
This causes the hours digits to flash.
Hours
3. Use (B) and (D) to change the timer hours
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
4. Press (C).
This causes the minutes digits to flash.
Minutes
5. Use (B) and (D) to change the timer
minutes setting.
6. Press (C).
This causes [ ] (Repeat Timer) or
[ ] (Auto Repeat Timer) to flash
on the display.
7. Press (D) to select Repeat Timer or Auto
Repeat Timer.
●
Each press of (D) toggles between
[ ] (Repeat Timer) and
[ ] (Auto Repeat Timer).
8. Press (C).
9. Press (D) to select [♪ON] or [♪OFF] as the
time up beeper setting.
[♪ON]: Beeper enabled.
[♪OFF]: Beeper disabled.
10. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Setting a start time of [0:00 00] will
perform a countdown of 24 hours.
Watch Operation Guide 3559
15
Loading ...
Loading ...
Loading ...