Loading ...
Loading ...
Loading ...
buttons at the same time for
approximately 2 seconds.
9.3 Deactivating the tank indicator
The water container indicator is activated by
default. It illuminates at the end of the drying
cycle or during the cycle if the water reservoir
is full. If the draining kit is installed the water
container is drained automatically and the
indicator can be deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programmes.
3. Touch and hold down Silent and Refresh
buttons at the same time.
One of 2 configurations is possible:
• the Tank indicator: is on if the
symbol appears - the water
container indicator is permanently
activated
• the Tank indicator: is off if the
symbol appears - the water
container indicator is permanently
deactivated
9.4 Operating hours counter
This function gives a possibility to display the
total operating time of the appliance in hours,
which is counted from the moment it is first
switched on. The actual operating time of the
cycles is shown (does not include pauses or
delayed start time).
To visualise this value, proceed as follows:
1. Switch the appliance on by pressing the
On/Off button.
2. Press and hold the Dryness Level and
Time Dry buttons for some seconds.
3. After 3 seconds the total hours operated
by the appliance are shown in the display:
e.g. if the operating time is 1276 hours,
the display shows the text Hr for 2
seconds then 12 for 2 seconds followed
by 76. This value is displayed with a
sequence of two digits at a time: the first
two digits indicate thousands and
hundreds, the second two digits indicate
tens and units.
To exit this mode, either press any button,
turn the selector knob or switch the appliance
off.
9.5 Factory Defaults
This function allows to restore the factory
default settings. The saved options and
working modes will be reset.
To activate this option follow steps below:
1. Switch the appliance on by pressing
On/Off button.
2. Wait approximately 8 seconds.
3. Press and hold the + Anti Crease and
Silent buttons for some seconds.
4. The appliance will acknowledge the
operation by displaying
.
If the procedure does not work (this could
be due to timeout or wrong keys
combination), switch the appliance off
and repeat the sequence from the
beginning.
10. CARE AND CLEANING
10.1 Cleaning the filter
At the end of each cycle the
Filter
symbol
comes on the display and you must clean the
filter.
The filter collects the lint during the
drying cycle.
20 ENGLISH
Loading ...
Loading ...
Loading ...