Loading ...
Loading ...
Loading ...
5
ENGLISH INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
FIGURE 1
1
Knife Holder
1. Remove the safety pin from the
gimbal pole. (FIGURE 1)
2. Separate the support post and
support bracket.
3. Lay the llet board upside down on
a at, level work surface with the open
end of the llet board is to the front and
the backsplash to the back (FIGURE
2).
4. Set the support bracket onto the llet
board / llet station near the holes with
the bracket post facing up. if you plan
to mount the llet board / llet station
port, orient the bracket post so that it
points to the right (FIGURE 3).
If you intend to mount the llet board
/ llet station starboard, orient the
bracket post so that it points to the left.
5. Line up the holes in the support
bracket with those in the llet board
/ llet station. there are three sets of
holes in the support bracket. you can
line up the four center holes or either
set of holes 15 degrees offset from the
center holes. the offset holes let you
better align the llet board / llet station
with your boat.
6. Insert an m6 x 40 mm at head
screw through one hole in the
llet board / llet station and the
corresponding hole in the support
bracket.
TOOLS REQUIRED:
10 mm wrench
Phillips screwdriver
Support Bracket
Gimble Pole
Support Post
Safety Pin
Support Bracket
Bracket Post
FIGURE 2
FIGURE 3
Loading ...
Loading ...
Loading ...