Broan BKDN136WH INSTALLATION, USE AND CARE MANUAL

Loading ...

INSTALLATION MANUAL

INSTALLATION

Install the Hood (EZ1 Bracket)

1 ] Run the house power cable between service panel and hood location.

2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B,

on front C and D on illustration below); these holes allow the range hood to hang on the

brackets (previously installed).

3 ] Temporarily hang the hood on the brackets using its 2 recessed REAR HOLES (A and B).

While holding the hood, run the house power cable into the hood through the strain relief

previously installed in step6 on page11.

4 ] Unhook the rear holes from the brackets and hang the hood using its 2 recessed FRONT

HOLES (C and D). While holding the hood, go to step 6.

5 ] Hang the hood on the brackets using the 2 recessed FRONT HOLES (C and D). While holding

the hood, tighten an appropriate strain relief, 1/2” diameter (not included) to the power cable,

then insert the strain relief in the knockout hole.

6 ] Connect ductwork to the hood and use metal foil duct tape to make joints secure and

airtight. Make sure the damper assembly (or round duct plate) enters the ductwork and

that the damper opens and closes freely.

NOTE: See final installation steps on next page.

DUCTED INSTALLATION ONLY

HORIZONTAL EXHAUST INSTALLATION

VERTICAL EXHAUST INSTALLATION AND NON-DUCTED INSTALLATION ONLY

OTE: N The following procedure applies to both framed or frameless cabinet installations.

Loading ...

Broan BKDN136WH Sahale 36-inch Under-Cabinet Range Hood, 450 Max Blower CFM, White