Loading ...
Loading ...
Loading ...
Operation
Auto O
This controller is fitted with a 8 hour count down auto OFF timer, which starts to
countdown from when your heat setting has been selected, and will switch o after
8 hours.
Note: Once a heat setting has been selected and the switch is powered ON, the
countdown timer will not be aected by adjusting heat level.
The timer will only be reset to 8 hours by sliding the control knob to “0” or after
being powered OFF and then back ON.
When the controller has timed out, slide the control to the “0” position to reset.
Preheat
At normal ambient temperature you should allow at least 15 minutes on heat setting
“3” to preheat.
You may get into bed sooner while the bed is still warming up, however DO NOT
leave the blanket on setting "3" while you are in the bed.
Note: A cold room or bed that has not been used for some time may require a
greater length of time on the pre-heat.
Overheat Protection
The blanket is fitted with an overheat protection system. This oers protection
against overheating or damage to the elements by disengaging the power to the
elements before overheating hazards occur. Disconnect the power supply before
there is a risk of overheating.
Should there ever be a problem with the heating element in the blanket, it will
automatically close down the operation and the blanket will turn o.
The controller has built in protection, so that if the controller overheats, or the
heating element is damaged, it will automatically close down the operation
permanently.
If overheating occurs, the blanket is permanently damaged and cannot be used
again. A replacement will be needed.
10
Loading ...
Loading ...
Loading ...