Loading ...
Loading ...
Loading ...
TRANSPORTING YOUR TILLER
AROUND THE YARD
• Pull forward on lift handle until it locks in the transport
(up) position.
AROUND TOWN
Disconnect spark plug wire.
Drain fuel tank.
Transport in upright position to prevent oil leakage.
TO ADJUST DEPTH STAKE
• The top depth stake hole selects a till depth of 1"
with each lower hole increasing till depth by 1" to a
maximum of 5".
• To change till depth, remove the hair cotter pin from
the clevis pin which is connecting the depth stake to
the stake support bracket.
• Grasp the top of the depth stake, remove the clevis
pin and reposition the depth stake. Insert clevis pin
and hair cotter pin.
iMPORTANT: THE DEPTH STAKE SHOULD NEVER BE
REMOVED FROM THE TILLER. IT IS DESIGNED TO
PROTECT THE TRACTOR TRANS AXLE FROM THE
THRUSTING ACTION OF THE TILLER.
TiLLiNG
Tilling should be done with the tiller engine full
throttle. If tiller engine seems to be overloaded or
stalls out, lower gauge wheels for shallower tilling.
Operate tiller engine at full throttle and operate tractor
in slowest forward speed with tractor engine at idle
speed or just above idle.
Soil conditions will determine how deep tiller can
penetrate on the first pass. In extremely hard ground,
several passes may be necessary to till to a depth of
6 inches. While in soft ground, tiller may penetrate to
a depth of 6 inches in the first pass.
TiLLiNG HINTS
iMPORTANT OPERATING HINTS
NOTE: The following are general guidelines for tilling, but
may vary depending upon soil conditions.
in virgin soil, the tiller should be started in shallowest
depth position and lowered one position at a time
after each pass in each direction.
Extremely hard and dry soil will need to be cross
tilled at a shallow depth first, then tilled in the
direction of planting rows on the second pass at the
final depth.
Till in a pattern similar to that shown in Figure 7.
Make the first pass, skip a space equal to the width
of the tiller and make the return pass, then till the
skipped area. Tilling in this pattern will enable you to
maintain better control, ifthe passes are made side-
by-side, the tractor and tiller will pull toward the tilled
(soft) side.
Check ground moisture. The ground is too wet if you
can make it into a ball with your hand. Tilling soil
when it is too wet will cause lumps which are difficult
to work up.
in soil that was tilled the year before, select the tilling
depth at which the tiller engine runs comfortable and
does not stall or pull down. Lower depth for additional
passes if great depth is desired.
Whenever working multiple passes, go perpendicular
to the previous tilling direction.
in cases where the soil is too hard to get proper
penetration or if tiling action causes tiller to hop or
bounce, it will be necessary to purchase a set of tiller
(wheel) weights.
CULTiVATiNG
A minimum of two (2) inches of soil penetration is
required for cultivating.
Set depth stake so the tiller penetrates soil to a depth
of 2 to 3 inches.
Run the tiller engine at full throttle except when
cultivating small plants. A slower engine speed
is necessary to prevent burying small plants.
See Figure 8.
i=
-- -5
---
m
u
FIGURE 7 FIGURE 8
Loading ...
Loading ...
Loading ...