Loading ...
Loading ...
Loading ...
12
5. Using the bottom edge of the cardboard plate across the two
small lines, draw a mounting plate bottom line.
A
B
C
A. Two Small Lines
B. Cardboard Plate Bottom Line
C. Bottom Edge of Mounting Plate
6. Draw four small circuit along with A & B & H & J holes.
A & B & H & J holes
Drill holes in Upper Cabinet
1. Using a drill, cut out the power cord hole (A).
2. Drill two mounting nut holes (B), which are 3/8" (10 mm) holes
at points “D” and “E” on the cardboard template. These are for
two 1/4-20 x 3" bolts and washers used to secure the
microwave oven to the upper cabinet.
A
B
A. Power Cord Hole
B. Mounting Nut Holes
NOTE: If upper cabinet is metal, the supply cord bushing
needs to be installed around the supply cord hole as shown.
A
B
A. Metal cabinet
B. Power supply cord bushing
3. Using a keyhole saw, cut out the rectangular roof venting
cutout area. Skip this step if for recirculation venting or wall
venting installation.
A
A. Roof Venting Cutout Area
Drill holes in Rear Wall
1. The mounting plate is located inside the inner foam in the
cavity, take it out. The mounting plate is folded, open it to
180 degree at plate.
2. Attach the at mounting plate to wall. Make sure the 4 holes on
mounting plate align with the A & B & H & J holes marked in
the “Mark Rear wall” section. And the Mounting plate center
markers align with the Center Mark.
A
B
C
D
E
A. Mounting Plate
B. A & B & H & J holes
C. Mounting Plate Bottom Line
D. Center Mark
E. Mounting plate center markers
Loading ...
Loading ...
Loading ...