Loading ...
Loading ...
Loading ...
6 7
PROBLEM POSSIBLE CAUSE SOLUTION
Water drips from the
holes in the soleplate.
You are using steam while
the iron is not hot enough.
Wait until the thermostat light
goes out.
You are using the shot of
steam button too often.
Wait a few seconds between
each use of the button.
You have stored the iron
horizontally, without
emptying it and without
setting it to .
See the section “Iron storage”.
Brown streaks come
through the holes in the
soleplate and stain the
linen.
You are using ironing
water additives (i.e.
scented water, starch).
Never use ironing water
additives; these will
permanently damage your
steam iron.
You are not using the
right type of water.
Perform a Self cleaning
operation and consult the
chapter “What water to use?”.
Your linen has not been
rinsed sufficiently or
you have ironed a new
garment before washing
it.
Make sure that your laundry is
rinsed sufficiently in order to
remove any deposits of soap
or chemical products on new
clothes.
The soleplate is dirty
or brown and can stain
the linen.
Your are ironing with an
inappropriate temperature
selection (temperature
too high).
Clean the soleplate (refer
to chapter 9). Select the
appropriate program.
You have ironed over a
printed area of a garment.
Never iron over printed areas
or applications – always iron
the reverse side of such a
garment.
There is little or no
steam.
The water tank is empty. Fill the water tank.
Your iron has been used
dry for too long.
Carry out a Self clean.
Valve pin is not correctly
in place.
Make sure valve pin is in
correct position.
Thermodial is not set to
steaming area.
Set thermodial between 2dot
and Max.
The soleplate is
scratched or damaged.
You have placed your iron
flat on a metallic rest-plate
or ironed over a zip.
Refrain from ironing over
metallic buttons or zippers.
Steam or water come
from the iron as you
finish filling the tank.
The steam control is not
set to the DRY
position.
Check that the steam control is
set to the DRY position.
The water tank is
overfilled.
Never exceed the Max level.
The spray does not
spray.
The water tank is not filled
enough.
Fill up the water tank.
If there is a problem?
• This product has been designed for domesic and indoor use only.
The manufacturer will accept no responsibility and the gua-rantee
will be terminated, if this product is used for commercial purposes,
inappropriate use or failure to comply with the instructions.
WHAT WATER TO USE?
Your appliance was designed to operate using untreated tap water.
However, it is necessary to periodically clean the steam chamber to
remove any mineral deposits. If your water is very hard (above 30°f or
17°dH or 21°e) mix 50% untreated tap water with 50% demineralised
water (available in hardware stores).
TYPES OF WATER NOT TO USE?
Do not use water with additive, pure demineralised or pure distilled
water, water from clothes dryers, scented or softened water, rain water,
filtered, bottled or boiled water, water from refrigerators, batteries,
air conditioners or rain water as these may damage the iron. These
types of water contain organic waste, mineral elements that become
concentrated when heated and cause spitting, brown staining, leaking
or premature wear on your iron
ENVIRONMENT
Environment protection first !
i
Your appliance contains valuable materials which can be
recovered or recycled.
Leave it at a local civic waste collection point.
Loading ...
Loading ...
Loading ...