Loading ...
Loading ...
Loading ...
4. Tilt the cutting unit to the applicable position.
5. Adjust the screw to set the friction.
6. Set the cutting unit in different positions to try the
friction.
To set the product in transport position
WARNING: Do not start the product
when the product is in transport position.
1. Push the stop switch to stop the product.
2. Install the transport guard on the cutting unit.
3. Pull down the position adjustment handle.
4. Fold the cutting unit to make it parallel to the shaft.
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
on the product.
Maintenance schedule
Maintenance Daily Weekly Monthly
Clean the external surface. After each operation.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted
lubricant.
After each operation.
Make sure that the cutting unit does not move at idle speed. X
Do a check of the stop switch. X
Examine the cutting unit for damages and cracks. Replace if it is damaged. X
Do a check of the throttle trigger lockout and the throttle trigger. X
Examine the engine, the fuel tank and the fuel lines for leaks. X
Tighten nuts and screws. X
1173 - 005 - 30.08.2023 13
Loading ...
Loading ...
Loading ...