Lexmark MS431DN User's Guide PDF

Loading ...

Exposure to radio frequency radiation

The radiated output power of this device is far below the radio frequency exposure limits of the FCC and other

regulatory agencies. A minimum separation of 20 cm (8 inches) must be maintained between the antenna and

any persons for this device to satisfy the RF exposure requirements of the FCC and other regulatory agencies.

Innovation, Science and Economic Development Canada

This device complies with Innovation, Science and Economic Development Canada license-exempt RSS

standards. Operation is subject to the following two conditions: (1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the

device.

Innovation, Sciences et Développement économique Canada

Cet appareil est conforme aux normes RSS exemptes de licence d'Innovation, Sciences et Développement

économique Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit

pas causer d'interférences et (2) il doit accepter toutes les interférences, y compris les celles qui peuvent

entraîner un fonctionnement indésirable.

Federal Communications Commission (FCC) compliance information

statement

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

The FCC Class B limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

• Consult your point of purchase or service representative for additional suggestions.

The manufacturer is not responsible for radio or television interference caused by using other than

recommended cables or by unauthorized changes or modiﬁcations to this equipment. Unauthorized changes

or modiﬁcations could void the user's authority to operate this equipment.

Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing

device, use a properly shielded and grounded cable such as Lexmark part number 1021231 for parallel attach

or 1021294 for USB attach. Use of a substitute cable not properly shielded and grounded may result in a

violation of FCC regulations.

Notices 147

Loading ...

Lexmark MS431DN