Loading ...
Loading ...
Loading ...
15
operaTion
= Lower hinge heating control
If condensed water appears in the lower hinge area
or on the base plate between refrigerator and freezer
compartment increase the output of the heating located
behind the base plate.
The factory setting is set to
= medium output
How to change the heating output
• Activate the setup mode by touching the Superfrost
icon for 5 seconds
• Touch the freezer compartment Down icon until
appears in the freezer temperature display.
• Touch the Superfrost icon
- the display shows
• Touch freezer compartment
Up/Down icons to select
= at slight condensation
= at heavy condensation
= heating off
• Touch the Superfrost icon at the desired value.
• Exit setup mode by touching the freezer compartment
On/Off icon.
Note
With normal ambient conditions no condensation will
appear. With high humidity and low ambient temperature
this feature helps to prevent condensation.
= Reset air filter LED
After the air filter in the toe kick area has been cleaned
the air filter LED must be reset. For how to clean the air
filter refer to chapter “Cleaning”.
How to reset the air filter LED
• Activate the setup mode by touching the Superfrost
icon for 5 seconds.
• Touch the freezer compartment Down icon until
appears in the freezer temperature display.
• Touch the Superfrost icon
- the display shows
• Touch the Superfrost icon again
- the display shows
• The air filter LED disappears.
• Exit setup mode by touching the freezer compartment
On/Off icon.
Figure 10
SuperFrost icon
Freezer On/Off icon
Freezer compartment Up/Down icons
Freezer temperature
display
Loading ...
Loading ...
Loading ...