Loading ...
Loading ...
Loading ...
• Remove the waterproof plug from the installed handlebar.
• Pull o the assembled handlebar protector, insert it into the
fork hole, adjust the angle (the center point of the handlebar
is perpendicular to the front wheel), make sure you can
insert the handlebar below the safety line into the head
tube of the frame, and lock it tight with hexagonal key.
• Make sure the handlebars are locked tight and do not move
from side to side (the locking torque is not less than 12N.m)
• Put the waterproof plug back in its original position.
www.SereneLifeHome.com8
MAINTENANCE INSTRUCTIONS
Adjusting Calliper Brakes
Throughout the life of your bike, the front calliper brakes may need adjusting if the brake cable has streched or the brake arms
have been knocked during use.
Adjusting the Caliper Cable Tension
1a
1a. Adjust the Brake Cable
The brake cable must be adjusted to ensure that the
brakes are close as possible to the wheel rim when no
pressure is applied to the brake lever but still allowing
freedom of wheel to rotate.
Using a suitable spanner or socket, loosen the cable
anchor nut until the brake inner wire/or cable is free to
move.
Pull the brake cable until the brake pads are approximately
3 to 4 mm from the wheel rim. Retighten the cable anchor
nut while holding the brake cable position.
Loading ...
Loading ...
Loading ...