Loading ...
Loading ...
Loading ...
54
55
WITHOUT BASE INSTALLATION
WITHOUT BASE INSTALLATION
INSTALL USING LAP-SHOULDER BELT
INSTALL USING LAP-SHOULDER BELT
While pushing down on the Child Restraint, pull up on the vehicle shoulder
belt to remove all slack from vehicle lap belt.
3
Put the vehicle seat belt in the locked mode. See vehicle owner's manual for more
information. A tightly rolled towel may be used under the front edge of the Child
Restraint if needed to adjust the angle of the Child Restraint. Angle is correct
when level line on Child Restraint is level with ground.
CHECK YOUR WORK
Hold Child Restraint at each side and pull side to side and forward.
Child Restraint should not move more than 1” (25 mm) from vehicle seat
back or side-to-side.
Make sure Child Restraint is level. Make sure infant’s head does not fall
forward. If necessary re-adjust recline and repeat installation steps to
make sure Child Restraint is installed properly.
Check installation before every use!
3
CHECK YOUR WORK
Loading ...
Loading ...
Loading ...