Loading ...
Loading ...
Loading ...
• In temperatures below -5°C/23°F, install the wear
guard with an air duct (D).
CAUTION: At temperatures of more
than -5°C/23°F or 0°C/32°F, remove the
winter kit from the product. There is a risk
of engine damages.
To lubricate the wire (555FXT)
Note: The wire is lubricated at the factory. Lubricate
the wire monthly.
1. Remove the protective cover.
2. Remove the cylinder cover to get access to the
rubber bellows on the wire.
3. Remove the plug on the grease nipple.
4. Use antifreeze spray with a 2 mm spray tube. Spray
in short intervals.
5. Examine the rubber bellows on the wire to make
sure that it does not expand.
6. Attach the cylinder cover and the protective cover.
Troubleshooting
The engine does not start
Check Possible cause Procedure
Stop switch. The stop switch is in the stop posi-
tion.
Let an approved servicing dealer re-
place the stop switch.
Starter pawls. The starter pawls cannot move free-
ly.
Remove the starter cover and clean
around the starter pawls. Refer to
To
clean the cooling system on page 25
.
Let an approved servicing dealer
help you.
Fuel tank. Incorrect fuel type. Drain the fuel tank and fill with cor-
rect fuel.
Carburetor Incorrect adjustment of the idle
speed
Adjust the idle speed with the idle
speed screw T.
30 1346 - 007 - 22.08.2023
Loading ...
Loading ...
Loading ...