Loading ...
Loading ...
Loading ...
11
Open the water tank and fill it with
clean water.
Close the water tank and shake it gently.
Pour out the remaining water as shown.
Remove the VibraRise mop cloth from
the VibraRise mop cloth mount. Clean
the VibraRise mop cloth and air-dry it.
C7-1—
*
Clean as required.
C8-1—
*
Clean after each use and replace every 3-6 months.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C7-2—
C7-3—
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Battery
The robot is equipped with a built-in high-
performance lithium-ion rechargeable battery
pack. To maintain battery performance, keep
the robot charged during normal use.
C9
Robot Sensors
C7
Water Tank
C8
VibraRise Mop Cloth
*
Clean monthly.
Wall Sensor
Reactive 3D Obstacle Avoidance
Sensor
Carpet Sensor
Cliff Sensors
C9-1—
C9-2—
C9-3—
C9-4—
C11
Air Duct
*
Clean as required.
C10
Dust Bag Replacement
*
Replace as required.
Note:
The dust bag handle seals the bag on removal to prevent
dust leakage.
C10-1—
C10-3—
C11-1—
C10-2—
C10-4—
C11-2—
C11-3—
Use a soft dry cloth to wipe the charging
contacts on the robot. Clean the dock
location beacon, charging contacts, and
electrode brushes on the dock.
C12
Charging Contact Areas
*
Clean as required.
Remove the dustbin cover vertically
as shown.
Clean the filter with a dry cloth.
Unscrew the screws (10) and
remove the cover.
Lift the dust bag out of the dustbin
and discard it.
Install a new dust bag in place
along the slot and put the dustbin
cover back.
Wipe the air duct and cover with a
dry cloth.
Reinstall the cover and screw it
back in place.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution.
Before disposing of this product, remove
the battery. The battery should then be
properly recycled either through local
authorities or by providing the batteries to a
battery recycling facility.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the clip to pull out the battery connector.
6. Remove the battery.
How to remove the battery:
Environmental protection
description
Note:
Notes:
The following information is only suitable for the
situation that the robot will be disposed of or its battery
cannot function normally after recharging.
• Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the charging dock.
• Remove the entire battery pack. Avoid damaging the battery
pack casing to avoid short-circuits or leakage of hazardous
substances.
• In the event of accidental contact with battery fluid, rinse
thoroughly with water and seek immediate medical care.
Loading ...
Loading ...
Loading ...