Loading ...
Loading ...
Loading ...
Specify the paper height and width
Defining a specific height and width measurement for the Universal paper size (in the portrait orientation) allows the
printer to support the size, including support for standard features such as duplex printing and printing multiple pages
on one sheet.
Note: Select Portrait Height to adjust the paper height setting or Paper Width to adjust the paper width
setting, or adjust both. Instructions to adjust both follow.
1 From the Universal Setup menu, press the up or down arrow button until Portrait Width appears, and then
press
.
2 Press the left or right arrow button until the setting you want appears, and then press .
Submitting selection appears, followed by the Universal Setup menu.
3 From the Universal Setup menu, press the up or down arrow button until Portrait Height appears, and
then press
.
4 Press the left or right arrow button until the setting you want appears, and then press .
Submitting selection appears, followed by the Universal Setup menu.
5 Press and release until Ready appears.
Specify a feed direction
Short Edge is the factory default setting for feed direction for Universal paper settings. The Feed Direction menu appears
only when both the height and width specified for the Universal paper size are set to 8.5 in (216 mm) or less. If necessary,
specify whether the short or long edge of the paper enters the printer first.
1 From the Universal Setup menu, press the up or down arrow button until Feed Direction appears, and then
press
.
2 Press the up or down arrow button until Short Edge or Long Edge appears, and then press .
3 Press and release until Ready appears.
Loading trays
1 Pull the tray completely out.
Note: Do not remove trays while a job prints or while Busy appears on the display. Doing so may cause a jam.
Loading paper and specialty media 45
Loading ...
Loading ...
Loading ...