Loading ...
Loading ...
Loading ...
14. Fine adjustments to drawer trim position.
The drawer slides each have a screw for adjusting the height
of the drawer trim, if necessary. The vertical adjustment
screw allows the top and bottom edges of the drawer trim to
be matched with the control trim.
15. Connect power at service entrance.
16. Check operation.
OPERATING INSTRUCTIONS
Always turn your hood on before you begin cooking to establish
an air flow in the kitchen. Let the hood run for a few minutes to
clean the air after you turn the range off. This will keep the whole
kitchen cleaner and brighter.
Controls
The hood is "OFF" when the drawer is pushed completely in.
LIGHT - The light will turn "ON" when the drawer is pulled and
out approximately 1/2 inch.
BLOWER - The blower will turn "ON" when the drawer is pulled
out approximately 1-1/2 inches.
The blower speed is set using the slide control, located to the
right of the drawer.
12. Connect electrical wiring.
Remove the wire box cover. Attach power cable to hood using
proper connector Connect black to back, white to white and
green or bare wire to ground screw. Replace wire box cover.
13. Install glass drawer assembly.
Slide the glass into the drawer slides, above each drawer clamp
(see illustration in Step 14). Align drawer trim and tighten thumb
screws to secure drawer.
To remove glass drawer:
Simply loosen thumb screws and pull glass from drawer slides.
CAUTION
DO NOT CONNECT POWER AT SERVICE ENTRANCE
AT THIS TIME.
4
CONTROL
TRIM
Loading ...
Loading ...
Loading ...