Loading ...
Loading ...
Loading ...
To Remove Starter and/or Bulb:
1. Unplug range or disconnect power.
2. Push down with thumbs on the front of the lens cover while
pulling up with fingers on the back of the lens cover.
bulb). Push back and down on the lens cover to lock into
position.
5. Plug in range or reconnect power.
3. Push release lever toward bulb. The left end of the light
assembly will raise up.
1 2 3
1. Starter
2. Release Lever
3. Bulb
4. To remove starter, turn it counterclockwise and lift out of its
mounting base.
5. To remove bulb, roll it forward or backward 90 ° until it clicks,
then lift out.
To Install Starter and/or Bulb:
1. Fit starter prongs into starter mounting base and turn
clockwise.
2. Slide bulb prongs into bulb mounting base ends. Roll the bulb
forward or backward 90° until it clicks.
For normal range use, it is not suggested to remove the oven
door. However, if necessary, follow these instructions. The oven
door is heavy.
Before Removing:
1. Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip.
1.Door Stop Clip
2. Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3. Repeat procedure for other door stop clip.
To Remove:
1. Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
\
3. Push down on the left end of the bulb mounting base. When
the assembly latches, it will click.
1, Removal Pins
2, Hinge Hanger
2. Carefully close the door until it rests against the door removal
pins.
3. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
4. Replace lens cover. Position the two rear lens cover tabs in
front of the two metal spring clips (located directly behind the
23
Loading ...
Loading ...
Loading ...