EN
Original Instructions
Version 1 – May 2022
Stock No. 28106/28111 Part No. TK58/BL
TK58/GR
USER
INFORMATION
Read this manual in full before attempting
to use this product and retain it for future
use. Always use the latest version of
the manual.
1. Voltage Tester
1.1 Scope
This product is designed to test the
voltage at a given point in a circuit and
to locate breakages in cables. Any other
application is considered misuse. Draper
Tools accepts no responsibility for
improper use of this product.
Voltage testing range: 12–250V AC/DC
1.2 Safety Information
WARNING! Working with electricity is
dangerous. Always consult a suitably
qualied person if you are not certain
of what you are doing. NEVER touch
the metal blade during use.
Important: This product is NOT
a screwdriver. Using it as such is
dangerous and may cause damage to
the user or tool.
1.3 Operating Instructions
Voltage Test
Place the blade into or onto a “live”
aperture or contact and press and
hold the “Direct Test” button. An
approximation of the voltage is
indicated on the LCD display.
Induction Test
To nd a broken cable, ensure that
the supply is live, press and hold the
“Induction Break-Point Test” button and
track the blade from the plug towards
the appliance. A lightning symbol is
shown on the LCD display until a break
is detected. Repeat the test to conrm
the location.
1.4 Disposal
Dispose of this tool in accordance with
local regulations.
• DO NOT dispose of this tool with
domestic waste.
• DO NOT dispose of this tool in
unsorted municipal waste.
• DO NOT incinerate.
• DO NOT abandon in the environment.
Helpline: +44 (0) 23 8049 4344 Sales Desk: +44 (0) 23 8049 4333
General Enquiries: +44 (0) 23 8026 6355 Website: drapertools.com
Email: [email protected]
Draper Tools Limited, Hursley Road, Chandler’s Ford, Eastleigh, Hampshire, SO53 1YF, UK
2. Snap-OKnife
2.1 Health and Safety Information
WARNING! The blade in this product
is very sharp. Do not extend the blade
more than two segments. Fully retract
the blade when it is not in use.
Important: ALWAYS wear safety
goggles during use. Excessive pressure
can cause segments to break o
unintentionally. Remove blade segments
when they become blunted or worn.
2.2 Operation Instructions
Use the tab to extend and retract the
blade as necessary.
To remove blunt segments, squeeze
and slide the black removal tool away
from the end of the knife body. Extend
the blade so that the blunt segment
is clear of the guard and insert the tip
into the removal tool. Use the removal
tool to snap the segment o the blade.
Alternatively, use pliers or another
suitable gripping tool to snap o
the blade.
Important: ALWAYS snap the blade
away from you.
3. Explanationofsymbols
MM
Metric sizing
Cr
V
Chrome vanadium steel
1/4"
1/4” hex drive
Do not incinerate or throw
onto re
Do not abandon in the
environment
– WEEE –
Waste Electrical & Electronic
Equipment
Do not dispose of this product with
domestic waste
UK Conformity Assessed
European Conformity
