Loading ...
Loading ...
Loading ...
Forfoodscontainingsugarinanyform,cleanupallspillsand
soilsassoonaspossible.Allowthecooktoptocooldown
slightly.Then,whilewearingovenmitts,removethespills
whilethesurfaceisstillwarm.Ifsugaryspillsareallowedto
cooldown,theycanadheretothecooktopandcancause
pittingandpermanentmarks.
Donotslidecookwareorbakewareacrossthecooktop.
Aluminumorcopperbottomsandroughfinisheson
cookwareorbakewarecouldleavescratchesormarksonthe
cooktop.
Donotcookpopcorninprepackagedaluminumcontainers
onthecooktop.Theycouldleavealuminummarksthat
cannotberemovedcompletely.
Donotallowobjectsthatcouldmelt,suchasplasticor
aluminumfoil,totouchanypartoftheentirecooktop.
Donotusethecooktopasacuttingboard.
Usecookwareaboutthesamesizeasthesurfacecooking
area.Cookwareshouldnotextendmorethan_/2"(1.3cm)
outsidethearea.
Coilelementsshouldbelevelforoptimalcookingresults.Burner
bowls,whenclean,reflectheatbacktothecookware.Theyalso
helpcatchspills.
CookwareshouldnotextendmorethanV2"(1.3 cm) over the coil
element. If cookware is uneven or too large, it can produce
excess heat, causing the burner bowl to change color. For more
information, see the "General Cleaning" section.
NOTE: Before removing or replacing coil elements and burner
bowls, make sure they are cool and the control knobs are in the
Off position.
To Remove:
1. Push in the edge of coil element toward the receptacle. Then
lift it enough to clear the burner bowl.
2. Pull the coil element straight away from the receptacle.
A. Surface cooking area
B. Cookware/canner
C. 7/_,,(1.3 cm) Maximum overhang
Use flat-bottomed cookware for best heat conduction and
energy efficiency. Cookware with rounded, warped, ribbed or
dented bottoms could cause uneven heating and poor
cooking results.
Determine flatness by placing the straight edge of a ruler
across the bottom of the cookware. While you rotate the ruler,
no space or light should be visible between it and the
cookware.
Cookware designed with slightly indented bottoms or small
expansion channels can be used.
Make sure the bottoms of pots and pans are clean and dry
before using them. Residue and water can leave deposits
when heated.
• Do not cook foods directly on the cooktop.
Hot Surface Indicator Light (under ceramic glass)
The hot surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area(s) is turned off.
3. Lift out the burner bowl.
To Replace:
1. Line up openings in the burner bowl with the coil element
receptacle.
\
\
2. Holding the coil element as level as possible, slowly push the
coil element terminal into the receptacle.
3. When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.
Loading ...
Loading ...
Loading ...