Loading ...
Loading ...
Loading ...
18
6. Depth gauges are small teeth on the cutter which protrude
in front of the cutting edge. In order for the chain to
cut eectively, the depth gauge must be lower than
the cutting edge. Therefore, after heavy use or multiple
sharpenings the depth gauge may require ling down.
Place the depth gauge tool over the chain. Ensure that a
depth gauge is exposed and protruding from the slot on
the tool. Using the at le, le down the depth gauge until
ush with the tool in a forward motion (Fig. 33).
7. Remove the depth gauge tool and round o the edge of
the depth gauge with your le.
8. Repeat for all cutters on both sides of the chain.
9. After sharpening, clean the saw of any metal lings or
dust, then tighten (Fig. 12) and lubricate the chain
(Fig. 16).
Battery Caution + Disposal
Always dispose of your battery pack according to federal,
state, and local regulations. Contact a recycling agency in your
area for recycling locations.
mCAUTION! Even discharged battery packs contain
some energy. Before disposing, use electrical tape to cover
the terminals to prevent the battery pack from shorting, which
could cause a re or explosion.
Fig. 33
Flat le
Depth gauge
File forward
Depth gauge tool
Flat le
Depth gauge
Depth gauge tool
Amount to
le down
Cutting edge
mWARNING! To reduce the risk of injury or explosion,
never burn or incinerate a battery pack even if it is damaged,
dead, or completely discharged. When burned, toxic fumes
and materials are emitted into the surrounding environment.
• Batteries vary according to device. Consult your manual
for specic information.
• Install only new batteries of the same type in your product
(where applicable).
• Failure to insert batteries in the correct polarity, as
indicated in the battery compartment or manual, may
shorten the life of the batteries or cause batteries to leak.
• Do not mix old and new batteries.
• Do not mix Alkaline, Standard (Carbon-Zinc), or
Rechargeable (Nickel Cadmium, Nickel Metal Hydride, or
Lithium-Ion) batteries.
• Do not dispose of batteries in re.
• Batteries should be recycled or disposed of as per state
and local guidelines.
Recycling + Disposal
The product comes in a package that protects it against
damage during shipping. Keep the package until you are
sure that all parts have been delivered and the product is
functioning properly. Recycle the package afterwards or keep
it for long-term storage.
WEEE symbol. Waste electrical products should not
be disposed of with household waste. Please recycle
where facilities exist. Check with your local authority
or local store for recycling regulations.
Service + Support
If your Sun Joe
®
24V-HCSWP-LTE cordless pruning saw
requires service or maintenance, please call 1-866-SNOWJOE
(1-866-766-9563) for assistance.
Model + Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
located on the housing of the unit. Copy these numbers into
the space provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
Serial #:
2
4 V - H C S
W
P - L T E
Loading ...
Loading ...
Loading ...