Loading ...
Loading ...
Loading ...
6
A Philips head screwdriver is required.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the collection tank. (fig.3)
4. Remove the contents from inside the collection tank, make sure you have all contents as listed on page 5.
(fig.4)
5. For dry vacuum cleaning, install the supplied reusable cloth filter. (fig. 5) See page 10 for filter
installation.
6. For wet vacuum cleaning, install the supplied foam filter. (fig. 6) See page 10 for filter installation.
7. Insert the casters into the respective sockets on the bottom of the base. Apply pressure until castors
snap into place. (fig.7)
8. Turn the collection tank upside down and fit the base assembly onto the tank. Secure the base to the
tank with the supplied screws. Verify that the base is assembled correctly. Do not over-tighten screw.
(fig.8)
9. Place the power head back on the collection tank, aligning the top section with the latches, and snap into
place. (fig. 9 & 10)
10. Insert the larger end of the hose into the desired port. (fig. 11)
11. Choose the desired accessories and insert onto the end of the hose. (fig. 12)
For your convenience this vacuum comes with a wall mounting support for storage.
IMPORTANT!
• Do not mount the rack over 5 feet from the floor.
• Do not screw the rack to drywall only. Secure the screws to a stud.
• Do not hang from or sit on the vacuum when on mounting rack.
12. Align the two screw holes so that they are over a stud and secure the mounting support to the wall stud,
as shown, with the two screws provided. (fig. 13)
13. Place the wet and dry vacuum cleaner into the support. (fig. 14)
GENERAL ASSEMBLY INSTRUCTIONS
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
Loading ...
Loading ...
Loading ...