Loading ...
Loading ...
Loading ...
9 ENGLISH
2. Align the tongue on the battery pack with the slot
on the mower then slide the pack until it locks in place
with a little click.
1
Fig.12
► 1. Battery pack
3. Insert the lock key in the place shown in the gure
as far as it will go.
1
Fig.13
► 1. Lock key
4. Close the battery cover rmly.
To remove the battery pack from the mower;
1. Open the battery cover while pressing the unlock
button.
2. Pull out the battery pack from the mower while
sliding the button on the front of the battery pack.
3. Pull out the lock key.
4. Close the battery cover.
Machine / battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts o
power to the motor to extend machine and battery life.
The machine will automatically stop during operation if
the machine or battery is placed under one of the fol-
lowing conditions.
Overload protection
When the machine/battery is operated in a manner
that causes it to draw an abnormally high current, the
machine automatically stops and the indicator lamp
lights up in red. In this situation, turn the machine o
and stop the application that caused the machine to
become overloaded. Then turn the machine on to
restart.
Overheat protection
When the machine is overheated, the machine stops
automatically and the indicator lamp lights up in red.
Let the machine cool down before turning the machine
on again.
Overdischarge protection
When the battery capacity becomes low, the machine
stops automatically and the indicator lamp lights up in
red. If the machine does not operate even when the
switches are operated, remove the battery from the
machine and charge the battery.
Protections against other causes
Protection system is also designed for other causes that
could damage the machine and allows the machine to
stop automatically. Take all the following steps to clear
the causes, when the machine has been brought to a
temporary halt or stop in operation.
1. Turn the machine o, and then turn it on again to
restart.
2. Charge the battery(ies) or replace it/them with
recharged battery(ies).
3. Let the machine and battery(ies) cool down.
If no improvement can be found by restoring protection
system, then contact your local Makita Service Center.
NOTE: The timing, at which the lamp lights up,
depends on the temperature at work place and the
battery pack conditions.
Indicating the remaining battery
capacity
1
Fig.14
► 1. Indicator lamp
When the remaining battery capacity gets low, the
indicator lamp blinks in red. By further use, the machine
stops and the indicator lamp lights up in red. In this
situation, charge the battery pack.
Loading ...
Loading ...
Loading ...