Ancona AN1542 User Manual

Loading ...

— 18 —

STEP 10B (cabinet hoods only)

Venting

• Depending on exterior ventilation chosen (see page 13), either exit the ducting through the ceiling or wall.

• Always use rigid type metal/aluminum duct tube (follow the building codes in your area) to

maximizeairow.Makesurethatthebackdraftapscanopen,toallowmaximumairow.

Connect the duct tube to the vent/damper and securely seal with certied aluminum or foil tape

so that it is air tight. Please check the building codes in your city to learn which tape product is

recommended.

• For internal recirculation, please visit anconahome.com to purchase a recirculation kit (sold

separately), and move locker (located next to motor) into position (see Figure #13).

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthata

qualified electrician determine that the ground path is adequate. A 120-Volt, 60

Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-ampcircuit,

fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

GROUNDING INSTRUCTIONS:

• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric

shock by providing an escape wire for the electric current.

WARNING: Improper grounding can result in a risk of electric shock.

• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto

whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,

have a qualified electrician install an outlet near the appliance.

• Therangehoodmustbeconnectedwithcopperwire/plugonly.Therangehoodshouldbeconnecteddirectlyto

the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/

CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-

connection kits that have been investigated and found acceptable for use with this model.

Installation

STEP 11B (cabinet hoods only)

Install Filters

To install lters, follow below steps (See Figure #14):

• Angle the lter into slots at the back of the hood.

• Push the button on handle of the lter.

• Release the handle once the lter ts into a resting position.

• Repeat to install all lters.

Fig. #14

Fig. #13

Loading ...

Ancona AN1542 30 Inch Stainless Steel Convertible Chimney Style Wall Mount Hood