Loading ...
Loading ...
Loading ...
04
Before seicing, all water circulation systems and pump controls must be o
position and release all the pressure from the system.
INSTALLATION
Use Teon tape on the thread before screw ttings to pump inlet and outlet pos so as to avoid
leakage. Do not over-tighten the ttings.
Warning: Keep product away from Children.
This pump is compatible with above-ground pools and spas. Locate the pump as close to the
pool and water level as possible. Do not add too many elbow pipes in the plumbing so as to
avoid suction reduction. It is highly recommended that the pump be placed in cool, d
places and avoid direct sunlight. Install the pump on a rm, level base or pad to meet all local
and national codes. Fasten the pump to a base or pad with screws or bolts to fuher reduce
vibration and stress on pipe or hose joints. The base must be solid, level, rigid, and
vibration-free.
WARNING: This product should be installed and seiced by a qualied pool professional.
All electrical wiring must be in conformance with applicable local codes, regulations, and
the National Electric Code (NEC).
It is strongly advised to protect the electrical components from direct sunlight though
this pump is designed for outdoor use.
If installed within an outer enclosure or beneath the ski of a hot tub or spa, adequate
ventilation and free circulation of air must be provided to prevent overheating.
Place this pump in a well-drained area, one that will not ood when it rains.
Do not install this pump in a damp or non-ventilated location. It requires free circulation
of air for cooling.
Do not run the pump d. Water acts as a coolant and lubricant for the mechanical shaft
seal. Running the pump d may damage seals, causing leakage, ooding, and voids
warranty. Fill strainer housing with water before staing the motor.
CAUTION
Loading ...
Loading ...
Loading ...