Loading ...
Loading ...
Loading ...
www.PyleUSA.com
USE AND INSTALLATION FOR REFLECTION FILM:
Please Note: HUD projects dashboard information on the car front wind-
screen , because the windscreen is double, which will make double reec-
tion on the windscreen when it works. The double reection will be
dierent cause of the dierent windscreen. If you can see clear of the
displaying information, then there is no need to use the reection lm. If
there is a double image, then please use the reection lm. First, please
put the non-slip mat on the dashboard, and then put HUD on it.
Reection lm can be stick to the position right above the HUD position
which can reect host screen to windscreen.
METHODS OF PASTING THE FILM:
1. Spray some water on the place that the lm will be pasted on, and then
use a dry cloth to clean it.
2. Take o the back side（marked 1) of reection lm, then paste it to the
window glass.
3. After you have adjusted the location, you can use a scratch board or
something else at to slick the lm and squeeze the water inside out
until there is no bubble or water in it.
4. Take o the protection lm (marked 2) of the reection lm. If the lm
cannot display the whole information, please adjust the non-slip mat to
move the position.
TECHNICAL PARAMETERS:
Environment temperature: - 40c- + 80c atmospheric pressure 86-106KPa
Relative Humidity: 10% -95% environmental noise <= 60dB (A)
Alarm sound level: "= 30dB (A)
Working voltage: 9V ~ 16Vdc (12Vdc / 400mA)
HUD size: 12.5*7.5*1.5(cm)
HUD Weight: 110 g
SOLUTION FOR COMMON PROBLEMS
1. The screen without any display,and no electricity
Reason: Start the car engine; check if the OBD cable line is tight; please
pull down the OBD cables repeatedly to ensure; check if HUD power
switch turns on. If theres still no display, please try it to another car to
test, analyze whether the car OBD diagnostic interface is good, if it is not
good, please repair it and try again.
6
Loading ...
Loading ...
Loading ...