Loading ...
Loading ...
Loading ...
Dishwasher Care and Maintenance
Daily Maintenance
• The control panel and exterior should be cleaned by using a lightly damp cloth. After
cleaning, make sure to dry thoroughly. Never use sharp objects, scouring pads, or harsh
cleaners on any part of the dishwasher. To remove spots or stains from the surface of the
interior, use a cloth dampened with water and a little vinegar.
• There may be some oil stains left on the edge of the dishwasher’s interior wall or door after
heavily soiled loads have been washed. To clean the edge around the door, only use a soft,
warm, damp cloth. Avoid getting water inside the door lock and electrical components.
• Regularly clean the door seals with a damp sponge to prevent odors from trapped food
particles in the door seal.
WARNING: Never use a spray cleaner to clean the door panel, as it may damage the door
lock and electrical components. Abrasive agents or paper towels should not be used due to
risk of scratching or leaving spots on the stainless-steel surface.
Protecting the Dishwasher from Freezing
Please take frost protection measures during the wintertime. After every wash cycle, take
the following steps:
1. Turn off the dishwasher. Cut off electrical power from the dishwasher.
2. Turn off the water supply and disconnect the water inlet hose from the back of the unit.
3. Drain the water from the inlet hose and inlet port (Use a pan or bucket to catch the water).
4. Reconnect the water inlet hose to the inlet port.
5. Remove the filter system and use a sponge to absorb the water that is in the filter (sump)
area.
If your dishwasher no longer works due to freezing or ice, please contact our after-sales service team.
General Tips
In order to keep your dishwasher in good working order, the following suggestions should be
observed:
• Before cleaning or performing maintenance, always remove the plug.
• After every wash - Turn off the water supply to the appliance and leave the door slightly
ajar so that moisture and odors are not trapped inside.
Spray Arms
The upper and lower spray arms can be easily removed for periodic cleaning of the nozzles,
preventing potential clogging. Wash them under running water and carefully replace them in
their seats, checking that rotary movement is in no way impeded.
To Remove and Clean the Spray Arms
1. Open the door and take out the basket.
2. Remove the lower spray arm by grasping the middle arm and pulling upwards. Unscrew the
upper spray arm by rotating counterclockwise.
3. Wash the arms under running water and brush each spray arm. Use tools with a sharp
point, such as a needle, to clean nozzles if needed.
4. Replace the lower spray arm to its seat by pushing downward until it clicks into place.
Replace the upper spray arm by screwing clockwise into its seat. Ensure that the spray arm
movement is not impeded before running another cycle.
Lower Upper
Lower Upper
• 21 • • 22 •
Loading ...
Loading ...
Loading ...