Loading ...
Loading ...
Loading ...
5
2. Desk Installation
Disassemble the desk clamp assembly by removing the clamp
adjustment screw and the three attachment screws from the
base plate.
Re-install the base plate with three retained attachment screws. Tighten securely.
From below the desk, insert retained clamp adjustment screw through Pad and up through the hole in the desk.
Thread screw by turning the knob into base plate but do not tighten completely at this time. Center the desk
mount assembly over the hole and then securely tighten screw.
Note: min. hole diameter =10mm (.4”)
max. hole diameter =70mm (2.75”)
2b. Hole Installation
Pad
Clamp Adjustment Screw
Base Plate
Rubber Pad
Attachment Screw
4mm Hex Key
14-04-247-933321.indb 5 5/6/2014 1:46:09 PM
Loading ...
Loading ...
Loading ...