Loading ...
Loading ...
Loading ...
Seasonal storage :
Freezing temperatures can cause timers to freeze and expand,
damaging the timer. At the end of the season or when there is
frost in the forecast, remove your timer from the faucet, remove
the batteries and be sure to store the timer indoors, away from
freezing temperatures.
Tips for Battery :
- Always use fresh Alkaline batteries
- Do not use rechargeable or any other type of batteries
- Remove the batteries at the end of the season before storing
- Batteries should last about one season. A schedule with
more frequent watering times can cause the batteries to drain
faster
Cleaning Your Timer
Understanding Zones :
- This is a timer allowing you to water four different
areas from the same faucet. Each zone can be programmed
with different start time.
- Do not run two zones at the same time as this will reduce
your water pressure.
- When using additional external sensors, it is recommended to
check the battery levels on a monthly basis.
Your timer should be cleaned periodically. From time-to-time, you
may get sediment or dirt build-up in your timer. Follow the
information below.
Turn off your water faucet. Remove the timer from the faucet
connection and your hose connections. Look at the filter
washer at the faucet connection input. Check that the filter
washer is clear of any built-up sediment.
1.
If the filter is dirty, remove the filter washer from the timer.
Clean out the filter washer by placing it under running water.
2.
Turn the timer upside down and activate the MANUAL mode.
This will open up the valves and allow you to run water into
the output connectors. By doing this, you can see if there are
any clogs in the water flow. Once you see the water flow is
correct, deactivate the MANUAL mode.
3.
Useful Tips:
Maintenance:
1.
2.
Filter
Should your unit need replacement after extended use, do not
dispose of it with the household waste, but in an environmentally
safe way.
- For outdoor use with cold water only
- Do not spray near electrical connections
- When not in use, rinse the tool with water to remove most of the
dirt, dry your tool, and store indoors
Waste produced by electrical machine items should not
be handled like normal household garbage. Please recycle
where recycle facilities exist. Check with your local
authority or retailer for recycling advice.
Disposal:
m CAUTION m
CAN ICES-3 (B)/NMB-3(B) Canada Statement :
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
( 1 ) This device may not cause interference; and ( 2 ) This device
must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : ( 1 ) l'appareil ne doit pas
produire de brouillage, et ( 2 ) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement
The device meets the exemption from the routine evaluation limits in
section 2.5 of RSS 102 and compliance with RSS-102 RF exposure,
users can obtain Canadian information on RF exposure and
compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation
dans la section 2.5 de RSS 102 et la conformité à l'exposition de
RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur
l'exposition et la conformité de rf.
FCC Statement :
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
( 1 ) This device may not cause harmful interference, and ( 2 ) this
device must accept any interference received, including interference
that may cause undesired operation.
Caution: Any changes or modications not expressly approved by the
grantee could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC RF exposure requirements, the device and the
antenna for this device must be installed to ensure a minimum
separation of 20cm or more from a person’s body. Other operating
congurations should be avoided.
Valve
Faucet
connection
mWARNING: This product can expose you to chemicals including lead,
which is known to the State of California to cause cancer and birth defects
reproductive harm, and styrene which is known to the State of California to
cause cancer. For more information go to www.P65Warnings.ca.gov
Loading ...