Loading ...
Loading ...
Loading ...
Note
●
Auto Light
is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
●
Configuring the Auto Light Setting
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (B) for at least three seconds
to
toggle Auto Light between enabled and
disabled.
●
[LT
]
is displayed while Auto Light is
enabled.
●
If you do not disable it manually, Auto
Light remains enabled for
approximately six hours. After that, it
becomes disabled automatically.
On
●
Specifying the Illumination Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when [SET
]
starts to
flash.
3. Press (C) 10 times to display [LIGHT
].
4. Press (D) to select an illumination
duration.
[1]: 1.5-second illumination
[3]: 3-second illumination
5. Press (A) to complete the setting
operation.
Time Adjustment
Use the procedures in this section to adjust the
date and time settings.
Adjusting the Current Time
Setting
Use the procedures below to adjust the
current date
and time settings, and to select a
Home City.
●
Setting a Home City
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area
that
observes summer time, you can also
configure a summer time setting.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when [SET
]
starts to
flash.
3. Use (B) and (D) to change the Home City
setting.
●
Holding down
(B) or (D) scrolls through
settings at high speed.
●
For details refer to the information
below.
l
City Table
Watch Operation Guide 5553
8
Loading ...
Loading ...
Loading ...