Loading ...
Loading ...
Loading ...
a
a
Check with a qualified electrician if you are not sure the
washer is properly grounded.
Do not have afuse inthe neutral or ground circuit.
1. 3 prong grounding plug
2. 3 prong grounding-type wall receptacle
3, Grounding prong
4, Power supply cord
GROUNDING INSTRUCTIONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the
risk of electrical shock by providing a path of least
resistance for electric current. This washer is
equipped with a cord having an equipment-grounding
conductor and a grounding plug.The plug must be
plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
WARNING: Improper connection of the
equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or
serviceman ifyou are in doubt as to whether the
appliance is properly grounded.
Do not modify the plug provided with the appliance -
if it will not fit the outlet, have a proper outlet installed
by a qualified electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be runwith the circuit conductors and
connected to the equipment-grounding terminal or
lead on the appliance.
INSTAILATION
INSTRUCTIONS
RemoveTransportSystem
IMPORTANT: Position the washer so that the rear ofthe unit is
within approximately 3 ft (90 cm) of the final location.
There are 4 bolts inthe rear panel of the washer that support the
suspension system during transportation. These bolts also retain
the power cord inside the washer until the bolts are removed
1. Using a 13 mm wrench, loosen each of the bolts.
2. Once the bolt is loose, move it to the center of the hole and
completely pull out the bolt, including the plastic spacer
covering the bolt. The power cord will be attached to all
4 bolts inside the washer.
3. Once all 4 bolts are removed, pull the power cord through
the opening of the rear panel and close the hole with the
attached cap.
4. Clase the bolt holas with the 4 transport bolt hole plugs.
NOTE: Ifthe washer is to be transported at a later date, call your
local service center.
7
Loading ...
Loading ...
Loading ...