Loading ...
Loading ...
Loading ...
TO REPLACETHE BULB BEHIND
THE LOWER CUHATEZONE TM
DRAWER:
° Turn the power off ("0") to the
refrigerator at the Main Power switch in
the upper machine compartment (see
page4).
• Unload and remove both Chmate-
Zone TM drawers.
• Remove the air diverter located at the
rear of the fresh food compartment, on
top of the upper ChmateZone TM com-
partment.
" Lift up and remove the glass shelf.
• After the shelf is removed, 2 mounting
screws are visible behind the upper
drawer. Using a X" hex head screw
driver, remove these screws,
° Slide the upper compartment assembly
forward.
• Disconnect the power cords at the plug
by pushing in the tabs and gent[), pulling
apart. Pull the assemblycompletely out
and set aside.
° Remove the hex head screws behind
the lower compartment,
Slide the lower compartment assembly
forward.
Unscrew the bulb and replace with a
new T8-40 watt bulb.
° Slide the assembly back into its original
position and align the screw holes.
Replacethe two screws.
• Lift the upper assembly back into its
original position leaving enough space
to reach the power cords.To reconnect
the upper assemb[7 power cords, align
the properly matching terminals and
snap the power cords back together,
• Push the assemblyback into its original
position and align the screw holes,
Replace the two screws and then
replace the glass shelf. Replace the air
diverter strip.
°Rep[ace the drawers.
• Turn the power back on to the refriger-
ator.
IMPORTANT:
• Do not remove the foam piece
between the ClimateZone TM drawers.
lOWER FREEZER
• Turn the power off ("0") to the
refrigerator at the btain Power switch in
the upper machine compartment (see
page4).
• Removethe freezer basketor ice drawer
that is located in front of the light (select
models).
• Using a phillips screwdriver, remove the
mounting screw on the light she[d.
• Unscrew the bulb and replace with a
T8-40 watt appliance bulb.
• Reinstall the light shield.
• Reinsert the freezer
basket or ice drawer,
• Turn the power back
on to the refriger-
ator. 1_ J
ICE AND WATER
DISPENSER lIGHT
TO REPLACE:
• Turn the power off ("0") to the
refrigerator at the Hain Power switch in
the upper machine compartment (see
page4).
• Locate the light bulb in the dispenser
area to the [eft of the actuator pad.
• Remove bulb.
• Replace the bulb, using a i20V, 7 watt
bulb.
• Turn the power back on to the refriger-
ator.
2O
Loading ...
Loading ...
Loading ...