Loading ...
Loading ...
Loading ...
10 JCT-2610 Series Rivet Buster
Problem Possible cause Remedy
Severe air leakage.
(Note: Minimal escape of
air is often normal for air
tools.)
Leakage from air inlet. Change O-rings and check for
loosening of air inlet nut.
Leakage from throttle valve area. Check for wear of throttle valve
elements. Replace as needed.
Excessive heat develops
in tool.
Improper lubrication. Lubricate properly according to
instructions in this manual.
Worn internal parts. Inspect and replace as needed.
Tool continues to operate
after releasing throttle
lever.
Throttle valve pin or bushing is
damaged.
Inspect and replace elements as
needed.
Blockage in valve area. Remove any foreign matter.
Steel tool is loose. Steel shank does not match
retainer bushing.
Use steel with correct shank type.
Upper sleeve is worn. Replace upper sleeve.
Replacement parts
Service parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial
number of your tool available when you call, so that we may serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from
JET.
Some parts are shown for reference only, and may not be available individually.
Loading ...
Loading ...
Loading ...