Loading ...
Loading ...
Loading ...
49-1000107 Rev. 5 19
REFRIGERATOR LOCATION
Ŷ Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
Ŷ Do not install the refrigerator where the
temperature will go above 100°F (37°C) because it
will not perform properly.
Ŷ Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
Ŷ Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
6LGHV ´PP
7RS ´PP&DELQHW+LQJH&RYHU
%DFN ´PP
Installation Instructions
INSTALLING THE REFRIGERATOR
IMPORTANT NOTES
This refrigerator without the handles ranges from
´WR´FPFPGHSHQGLQJRQ\RXU
model (see dimension E on the previous page). Doors
and passageways leading to the installation location
PXVWEHDWOHDVW´FPLQRUGHUWROHDYHWKH
doors attached to the refrigerator while transporting
it into the installation location. If passageways are
less than ´ (91.4 cm), the refrigerator doors can
easily be scratched and damaged. The doors can be
removed to allow the refrigerator to be safely moved
indoors.
• If you need to remove the door, see Removing
French Doors.
• To remove the freezer door, see Removing
Freezer Drawer.
• If it is NOT necessary to remove doors, leave tape
and all packaging on doors until the refrigerator
is in the final location. Once in place, install door
handles (see Steps 1 and 2).
• SKID REMOVAL: Tilt refrigerator to each side to
remove skid.
• NOTE: Use a padded hand truck to move this
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
ATTACH REFRIGERATOR
HANDLES
Attach refrigerator handle to the mounting
fasteners by aligning the slots on the handle with
the mounting fasteners. Slide the handle down
until it comes to a hard stop.
NOTE: For
French Door
models, follow
the same
procedure for
both doors.
Verify handle
is securely
attached by
pulling handle
upwards.
1
Mounting
Fasteners
INSTALLATION INSTRUCTIONS
ATTACH FREEZER HANDLE
Follow instructions for corresponding
fastener type
WARNING
Improper handle installation
may allow the handle to detach when it is used to
open the freezer door. A handle that detaches while
in use may cause the user to lose their balance,
which creates a fall risk.
Before You Start….
Ŷ To avoid injury, wear closed-toe shoes when
installing the handles.
Ŷ While installing the handle, grasp the handle
firmly to ensure it does not fall or scratch the
appliance’s finish.
Ŷ IMPORTANT: To make sure the handles are
accurately installed, please review the instructions
and graphics before you begin installation.
Loading ...
Loading ...
Loading ...