Loading ...
Loading ...
Loading ...
en
12
Changing LED lamp
1. Unplug the appliance from the mains or switch off
the circuit-breaker.
2. Unscrew screw.
3. Remove cover strip.
4. Unscrew LED lamp.
5. Screw the new LED lamp into the socket
(220 - 240 V AC, socket E14, max. 1.6 watts).
6. Insert cover strip.
7. Apply and tighten screw.
8. Switch on the appliance.
Saving energy
■ Install the appliance in a dry, well ventilated room.
The appliance must be installed out of direct sunlight
and away from heat sources (e.g. heating elements,
cooker).
Use an insulating plate if necessary.
■ Allow hot food and drinks to cool before placing
them in the appliance.
■ Place frozen food in the fridge compartment to
defrost and utilise the low temperature of the frozen
food to cool other food.
■ Only open the appliance for as short a time as
possible.
■ To prevent the food warming up quickly in the event
of a power cut or a fault, place blocks of ice directly
on top of the food.
■ A layer of frost in the freezer compartment impairs
the cooling effect on the frozen food and increases
the power consumption. If there is a layer of frost,
you must defrost the appliance.
■ To prevent increased power consumption,
occasionally clean the air vent with a soft brush or
vacuum cleaner.
■ If only medium quantities of food (approx. 40 %-60 %
of the maximum freezing capacity) are frozen, you
can put food into the freezer after 6 hours of super
freezing and switch super freezing off.
Operating noises
Completely normal noises
Humming
Motors running (e.g. refrigeration units, ventilator).
Bubbling, whirring or gurgling noises
Refrigerant circulating through the pipes.
Clicking
Motors, switches or solenoid valves are switching on/
off.
Preventing noises
The appliance is not standing straight
Make sure the appliance is exactly level by using a
spirit level. Level out any unevenness in the ground
using support spacers.
The appliance is touching adjacent units or
appliances
Move the appliance away from adjacent furniture or
appliances.
Baskets or separating plate are wobbling or sticking
Check the removable parts and re-insert them if
necessary.
Containers are touching
Move the containers apart slightly.
Loading ...
Loading ...
Loading ...