Loading ...
Loading ...
Loading ...
13 ENGLISH
Saw chain is automatically lubricated when the tool is in
operation. Check the amount of remaining oil in the oil
tank periodically through the oil inspection window.
1
2
Fig.20
Ź1. Oil tank cap 2. Oil inspection window
7R¿OOWKHRLOSHUIRUPWKHIROORZLQJVWHSV
1. Clean the area around the oil tank cap thoroughly
to prevent any dirt from entering the oil tank.
2.
Lay the chain saw on its side and remove the oil tank cap.
3. Fill the oil tank with the oil. The proper amount of
RLOLVPOÀR]
4. 6FUHZWKHRLOWDQNFDS¿UPO\EDFNLQSODFH
5. Wipe away any spilt chain oil carefully.
NOTE:
,ILWLVGLႈFXOWWRUHPRYHWKHRLOWDQNFDSLQVHUWWKH
slotted screwdriver into the slot of the oil tank cap, and then
remove the oil tank cap by turning it counterclockwise.
1
2
Fig.21
Ź1. Slot 2. Slotted screwdriver
$IWHUUH¿OOLQJKROGWKHFKDLQVDZDZD\IURPWKHWUHH6WDUW
it and wait until lubrication on saw chain is adequate.
Fig.22
Working with the chain saw
CAUTION:
7KH¿UVWWLPHXVHUVKRXOGDVDPLQL-
mum practice, do cutting logs on a saw-horse or cradle.
CAUTION: When sawing precut timber, use a
safe support (saw horse or cradle). Do not steady
the workpiece with your foot, and do not allow
anyone else to hold or steady it.
CAUTION:
Secure round pieces against rotation.
CAUTION: Keep all parts of the body away
from the saw chain when the motor is operating.
CAUTION: +ROGWKHFKDLQVDZ¿UPO\ZLWK
both hands when the motor is running.
CAUTION: Do not overreach. Keep proper
footing and balance at all times.
CAUTION:
When you use the upper side of the
guide bar for cutting, be careful since the chain saw may
be pushed in your direction if the saw chain is trapped.
NOTICE: Never toss or drop the tool.
NOTICE: Do not cover the vents of the tool.
NOTICE: When making several cuts, switch the
FKDLQVDZRႇEHWZHHQFXWV
Felling a tree
CAUTION: Felling work may only be per-
formed by trained persons.7KHZRUNLVKD]DUGRXV
When cross-cutting/bucking and felling operations are
being performed by two or more persons at the same
time, the felling operations should be separated from
the crosscutting/bucking operation by a distance of at
least twice the height of the tree being felled. Trees
should not be felled in a manner that would endanger
any person, strike any utility line or cause any property
damage. If the tree does make contact with any utility
OLQHWKHFRPSDQ\VKRXOGEHQRWL¿HGLPPHGLDWHO\
The chain saw operator should keep on the uphill side
of the terrain as the tree is likely to roll or slide downhill
after it is felled.
An escape path should be planned and cleared as nec-
essary before cuts are started. The escape path should
extend back and diagonally to the rear of the expected
line of fall as illustrated.
1
2
2
3 3
Fig.23
Ź1. Felling direction 2.'DQJHU]RQH3. Escape route
Loading ...
Loading ...
Loading ...