Loading ...
Loading ...
Loading ...
Lawn mower
The warning indicator (error LED) is found below the
battery lid.
Problem
Number
of flashes
on the er-
ror LED
Cause Solution
Error LED flashes.
The product does not
operate correctly.
5
The blade is blocked.
Turn the safety key to 0 to prevent accidental start. Re-
move the battery and wait a minimum of 5 seconds. Re-
move possible obstacles and make sure that the blade
can rotate freely. If the problem continues, speak to your
Husqvarna servicing dealer.
The motor speed
drops too much, and
the motor stops.
Increase the cutting height. Refer to
To set the cutting
height on page 13
.
10
The motor control is
too hot.
Stop the motor and wait until it has become cool.
Error LED flashes.
The product stops.
0
Battery connector
failure.
Examine the battery connector.
3
There is overload in
the motor.
Increase the cutting height. Refer to
To set the cutting
height on page 13
.
8 The battery is weak.
Charge the battery. Refer to
To charge the battery on
page 14
.
9
Battery error or no
signal from battery.
Put the battery in the product correctly and examine the
battery connector. If the error LED on the battery flashes.
Refer to
Battery on page 17
.
12
Incorrect start pro-
cedure. The motor
brake handle has
been engaged before
the motor starts.
Release the motor brake handle and wait approximately
5 seconds. Push the motor brake handle down again to
start the product.
Other errors.
If other errors occur, turn the safety key to 0, remove the battery and speak to your Husqvar-
na servicing dealer.
Transportation, storage and disposal
Introduction
WARNING: To prevent accidental start
during transport and storage turn the safety
key to 0, remove the battery and wait a
minimum of 5 seconds.
To set the product in transport position
1. Push the height adjustment bail with your foot. (Fig.
38)
2. Pull up the handle and pull out the height adjustment
bail from the groove.
3. Fold the handle forward until it has reached the end
position. (Fig. 39)
4. Fold the height adjustment bail towards the cutting
cover. (Fig. 40)
5. Release the handle knobs. (Fig. 41)
6. Fold the upper handle rearwards. (Fig. 42)
18 1869 - 005 - 31.08.2023
Loading ...
Loading ...
Loading ...