Loading ...
Loading ...
Loading ...
Installation instructions en
21
‒ Attach the exhaust air hose for the fan box to the
connector.
‒ Slide the fan box into the guide and tighten this
with a screw.
‒ Mark the position of the pipework on the bottom
of the unit.
‒ Undo the screw and remove the fan box again.
5.
Saw out the cut-out for the pipework.
6.
Slide the fan box into the guide, connect the pipe-
work and screw the fan box tightly back in place.
7.
Support the appliance from below and remove the
slats.
8.
Insert the appliance fully in the cut-out.
9.
Note:The design profile holders are not grip ele-
ments. Do not grip the appliance by the design pro-
file holders.
Observe the enclosed installation instructions for
special accessories.
Insert the design profile holder onto the short side
of the appliance.
Lift the appliance approx. 5mm in order to insert
the design profile holder.
10.
Align the rails to the bottom and attach to the
side .
11.
Screw the rails onto the bottom of the unit.
12.
Note:If an appliance measuring 90cm is installed
in a unit with a width of 90 cm, skip the next two in-
stallation steps and follow the instructions in the ad-
ditional accessory pack.
Screw in the screw from below and tighten the nut.
13.
Align the appliance to the hob and tension it
against the worktop .
Loading ...
Loading ...
Loading ...