Loading ...
Loading ...
Loading ...
Getting through narrow spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the
toe grille (see "Installation" section).
3 Remove any food from the door shelves
and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift inside edge of hinge cover and tilt
back.
Front
Cover Screw _ Rear
Top Hinge _"_ _c°vewr
Cover
Hing Ground
Screws_ _ Screw
Multi-
Cables -_ Top
/H: ge
Leave f_ /_[._)]
Hinge/ |1_ J _:_7,/j/i
With "_¢_1_-_ _ _-----I_.W. ater
Door -I\_,![ _ "-_Jne
Rear
Cover
Screw
Front
_p Hinge
Top Ground Hinge
Hinc
Cables
Leave
To remove the refrigerator doors:
1 Trace lightly around the door's top hinges
with a pencil. This makes reinstallation easier.
2 Disconnect the harness by grasping both
sides of the connector firmly, depress the
latch, and pull apart. Remove the two
screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
3 Detach the water tube from the connector
located behind the refrigerator and pull
the tube back out to the front of the unit.
The connector releases when you press
inward on the outer sleeve while pushing
the tube toward the connector then while
continuing to hold in the sleeve, pull the
tube away.
Use care while pulling the water tube from
the unit to be sure that you do not kink the
tube.
/
Door
DO NOT remove the ground screw from hinge.
Loading ...
Loading ...
Loading ...