Loading ...
Loading ...
Loading ...
Making an electrical connection
Before making a connection, check that:
· The mains voltage is the same as that quoted on the rating plate which
is situated at the back of your hob.
· The circuit can support the appliance load (see the rating plate).
· The power supply has an earth connection, which complies with the
provisions of current regulations and is in good working order.
· The fused switch is easily accessible once the has been
installed.
If there is no dedicated hob circuit and fused switch, they must be
installed by a qualified electrician before the is connected.
cooktop
cooktop
An approved suitable cable must be connected from the Consumer Unit
main fuse box and be protected by its own 32amp fuse or Micro Circuit
Breaker (MCB). The electrician must provide a fused all pole switch,
which disconnects both the line (live) and neutral conductors with a
contact seperation of at least 3,0 mm.
The fused switch should be fitted to the kitchen wall, above the
worksurface and to the side of the hob, not above it, in accordance with
IEE regulations. Connect the fused switch to a junction box which should
be fitted on the wall about 61cm (24 inches) above floor level and behind
the The 's power supply cable can then be connected.
Connect one end to the junction box and connect the other end to the
's power connection box which is located at the back of the hob.
Remove the cover of the power connection box and install the cable, in
accordance with the connection diagram.
cooktop. cooktop
cooktop
7
Loading ...
Loading ...
Loading ...