Loading ...
Loading ...
Loading ...
Troubleshooting en
47
Fault Cause troubleshooting
Detergent residue in the ap-
pliance
Washing effect and dissolv-
ing performance are re-
duced after a prolonged
storage time or detergent is
very lumpy.
▶
Change your detergent →Page31.
Water marks on plastic
parts.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
▶
Select a more intensive pro-
gramme.
▶
Position tableware at an angle.
→"Arrange tableware", Page34
▶
Use rinse aid.
→"Rinse aid", Page30
▶
Set the water softening system
higher.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your detergent →Page31.
▶
Clean the appliance mechanically.
White coating is deposited in
the appliance interior.
1. Set the water softening system cor-
rectly.
In most cases you will need to in-
crease the setting.
2. Change your detergent if required.
Special salt dispenser is not
screwed tight.
▶
Screw the special salt dispenser
tight.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your detergent →Page31.
▶
Clean the appliance mechanically.
The hardness range is set in-
correctly or the water hard-
ness is greater than 44°E
(6,2mmol/l).
▶
Set the Water softening system
→Page27 to the water hardness
or add special salt.
3in1/organic/eco detergent
is not effective enough.
▶
Set the Water softening system
→Page27 to the water hardness
and use separate detergents (pro-
prietary detergent, special salt,
rinse aid).
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change Detergent
→Page31.
Loading ...
Loading ...
Loading ...