Loading ...
Loading ...
Loading ...
ASSEMBLY
&+$,17(16,21),*
Chains stretch with use, check and tension often. Never tension a warm chain before storing, as
chains shrink when cool; this can damage chain, bar and saw.
LOCKING KNOB
ADJUSTING
BLOCK
1. Release chain tension by turning
the tensioning screw, located behind
the chain bar, counter-clockwise.
2. Unscrew the locking knob. 3.Remove the cover.
4. The bar and chain can now be
removed by lifting it away from the
main body of the saw and releasing
the chain from the sprocket.
5. The pole saw can now be cleaned
with a brush and or rag to remove
sawdust and oil.
6.To replace the bar and chain, loop
the chain over the drive pulley and
place the bar against the center
alignment groove.
7. Ensure that the adjusting block is
located in the tensioning hole on the
chain bar.
8. Until that the rubber block and chain
bar are free from oil, as this helps to
keep tension on the chain.
9. Replace the side cover and locking
knob, but do not tighten.
10. Using a screwdriver on the
tensioning screw, turn clockwise.
11. Tighten until there is enough play
that the chain can be pulled away
from the bar, but not so much that
the runners can be pulled out of
the bar.
12. Once you have the correct tension,
fully tighten the locking knob.
),*
Loading ...
Loading ...
Loading ...