Loading ...
Loading ...
Loading ...
Setting Surface Controls
Dual radiant surface element (some models)
To operate the dual radlont element:
1. Place correctly sized cookware on single radiant surface
element.
. Push in and turn the surface control knob clockwise to
begin heating both the inner and outer portions of the
element (marked dual - See Fig. 2). If only the inner
heating portion is needed (marked single - See Fig. 1) for
smaller cool<ware, push in and turn the knob counter-
clockwise to start.
Please note that you may switch from the single or dual
settings at any time during cooking.
3. When cooking is complete, turn the radiant surface
element OFF before removing the cookware.
important notes:
° For efficient cooking, turn OFF the element several
minutes before cooking is complete. This will allow
residual heat to complete the cooking process.
° The surface control knobs do not have to be set exactly
on a particular spot. Use the graphics provided as a
guide and adjust the control knob as needed. Each
surface element provides a constant amount of heat at
each setting. Refer to the Suggested rodlont surface
e_ement settings table for suggested power level settings.
@
RJent Front
©
Right Front
000
0
Fig. 1 Fig. 2
Heating with inner Heating with both
(small) element only elements
Areas that heat are shown darkened.
* Start most cooking operations on a higher setting and
then turn to a lower setting to finish cooking.
Radiant elements have a iimiter that allows the radiant
heating element to cycle ON and OFF, even at the HI
setting. This helps prevent damage to the ceramic
smoothtop. Cycling at the HI setting is normal and will
occur more often if the cookware is too small for the
radiant element or if the cookware bottom is not fiat.
* A glowing red surface heating area extending beyond
the bottom edge of the cookware indicates the cookware
is too small for the surface heating area.
Radiant surface elements may appear to
have cooled after they have been turned off. The gloss
surface may still be hot and burns may occur if the glass
surface is touched before it has cooled sufficiently.
Do not place pIosflc items such as salt and
pepper shakers, spoon holders or plosflc wrappings on top
of the range when it is in use. These items could melt or
ignite. Potholders, towels or wooden spoons could catch fire
if placed too close to the surface elements.
Do not allow aluminum foil, empty glass/
porcelain cookwore or ANY moterlol that con melt to
make contact wlfh the ceramic cookfop. If these items melt
on the cooktop they may damage the ceramic cooktop.
12
Loading ...
Loading ...
Loading ...